Titan Centering Microscopes have an upright image, optically correct from left to right so that the operator sees the workpiece with the microscope the same as without it, mistakes due to transposing or converting are eliminated.
The X & Y & Z Series Centering Microscopes all come with hardened and ground 1/2" x 3" diameter shanks so that they are adaptable to all machines through the use of collets. It is suggested if it will be used continuously in one machine that it be fitted with its own collets.
The most minute spindle run-out can be compensated for both the X & Y &Z Series Centering Microscopes and the X Series uses the popular (3) master centering screw method where the reticle floats between the centering screws just below eyepiece of the microscope. The Y & Z Series have a "Prismatic" centering device where only two screws are needed for especially simple and fast centering to compensate for spindle run out. The prismatic setting on the Y & Z Series has the advantage of not changing the settings of one axis while you are adjusting the other axis, as both settings are entirely independent of each other. Both methods can be quickly mastered. Special instructions come with the units. It is an easy matter to adjust the microscope for perfect centering every time.