Pro Series Radius & Angle Dresser - 3800-5227

• Positive setting of the diamond to absolute center with the special gauge included with the dresser
• Simple, fast, accurate radius setting; no height gauge or other set-up aids required.
  Radius is set on the grinder by measuring over the two pins or by inserting a gauge block, as shown, for direct reading, Inside or outside radius is determined simply by sliding the dowel pin to the right for a concave and to the left for convex.
• 4x90° graduation in full 360° circle. 6 minute vernier reading.
• One push-pull type knob for radius and angle control and for safer and faster operations
• Accuracy - extremely close tolerances are held in the manufacture of this tool, assured by hardening and precision grinding of all critical parts. Ways are chrome hardened.
• Economy - set-up & dressing time reduced to a bare minimum due to simplicity

Specifications:

View Replacement Diamonds:

• 3900-0097
• 3900-0077
• 3900-0078
• 3900-0086
• 3900-0087
• 3900-0088